In nearly all cases, most people spend quite a bit of money purchasing their forklift. Therefore, it is very important to take good care of it in order to protect your investment well into the long run. It is a great idea to know the procedures which are undertaken during taking care of and maintaining this machinery.
Among the best ways to tell how good the engine is working is by starting the forklift up and listening carefully to see how it runs. For example, if there are any misses or knocks, the machinery is faulty and this should raise some issues. Additionally listen closely for any squealing noise which come from the belts since these sounds would provide you with a wealth of information.
When carrying out maintenance, several of the main parts you would have to pay attention to include the horn, safety warning devices, the overhead guard, the lights and the gauges. Any burnt out light bulbs or faulty parts must be replaced as soon as they are noticed. It is also essential to check the wiring.
The battery compartment terminals should be cleaned when the above components have been checked thoroughly. If the terminals are not clean, be sure to clean them properly. Each cell of the battery needs to be inspected in order to make sure that the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the machinery and then change the filters. The transmission filter, fuel filters and the hydraulic filter should be regularly replaced. Prior to fitting them, be sure to write the date on the new filters by using a permanent marker to be able to keep track.
When the oil change has been done and new filters have been fitted, visually inspect the drive axle from underneath the machine. Be certain to grease the axle if there is any grease fitting. Inspect the engine belts for any cracks or frays. If you find any, fix the problem accordingly. Afterwards, inspect every other component of the machinery like the wheels. If any type of fault or issue is detected, be sure to address it immediately in order to make certain the machine is running at its safest and optimum levels.